sidebite on RR under entry HELP

[pwmiller54]

The track I'm running gets pretty hard and slick and I'm having issue with getting side bite on the RR when entering the turn. When the track glazes over a bit, the car is very hard to drive under entry. I could loop it very easily if I don't take it easy. Also, it's obvious to me that I'm getting beat there a little bit. Any suggestions on how to improve this sidebite under entry? I'm not sure I can load the RR up any more without sacrificing forward bite. I'm not sure that I can put any more angle in my panhard/J-bar without sacrificing forward bite. Any suggestions?

[0jcrew]

what type of bar angles?

[profab00]

I once read a more famous guy give advice that to tighten entry was simply more spring in the left front/right rear. That actually was cited for side bite all the way around the corner.

[kas111]

As OJ said, you really need to give a little info about your current setup. Adding RR as mentioned above would be a likely way to add rear sidebite providing the setup is close otherwise but we don't even know if you are on a 4 bar car, j-bar or panhard bar, running low/no wedge, three wheel brakes, what the spring rates are, etc.