LR drive under car

[Dirtjunkie]

Ok guys maybe this is too general a question but how do I get the lr to drive up under the car more. The car is pretty good but just doesnt get the lr up under the car a whole lot. Nothing big just curious on your opinions.

[ScottyRocket]

Increasing the angle in your left bars would help.

What's the details on the car and setup now?

[Rocket Bonehead]

Increasing the angle won't neccessarily help. You can have too much angle and thus lose lift (been there, done that) and forward drive.



DJ-

Your question is too "generic". You need to provide more information, specific to your car and the tracks you run, so that we can pinpoint (if any) problems that could be keeping the car flat. Feel free to email me if you don't want to post that info here.



RB

[ScottyRocket]

If you want it "up under the car more", then raise the Left lower bottom. That addresses the specific question. That changes the radius that the bottom of the bird cage is getting pulled in. It also influences other things as well. This is also making the assumption that the car is already hiking on the left rear.

Yes, technically it could be something else that would cause it to not get up with what you have and not allow the left rear to pull up.... i'll let the experts dissect the issue any further.

[Dirtjunkie]

thanx guys as far as my bar angles goes it hard to say what they are because we move them all around but start out with a standard mastersbuilt setup on bars.I run a low wedge setup usually around 100 to 110# bite and although the car works pretty good it just doesnt get up on the bars real well. I am currently on a 475 lf 400 rf and a pair of 225 rears with about 4 1/2 to 5 inches rollout. I probably could use more wedge but am afraid of getting the car too tight although knowing that getting it up on the bars would pin the rf more helping. Mainly just wondering out loud but thanks for the replies.:D

[ScottyRocket]

DJ,

What shocks are you running?

[Dirtjunkie]

Ohlins double adjustable

[ScottyRocket]

Ok, what valvings roughly?

[Dirtjunkie]

thanx for the help everyone ,changed lr spring upped wedge, lots better